Compatibility between products

Frequent Asked Questions - READ FIRST

Compatibility between products

Postby hipogrito » Wed Oct 23, 2013 10:45 am

Hi,

I'm going to open this FAQ entry to explain some of the issues that happen when loading objects created in product X into product Y.

Instead of just throwing out a long message here, I'll be writing some posts in this thread with specific issues. Hope that clarifies some of the frequent problems people face while doing this.
Regards,

Fran
http://www.hipogrito.com
Yes I work at Kurzweil but anything I write here is just on behalf of myself, not the company.
User avatar
hipogrito
Site Admin
 
Posts: 926
Joined: Sat Feb 26, 2011 12:43 pm
Has thanked: 1121 times
Have thanks: 317 times

Re: Compatibility between products

Postby hipogrito » Wed Oct 23, 2013 10:54 am

Hi,

Loading setups created in the PC3/PC3K/PC3LE into the SP4, SP5 or Artis.


Note that in Artis setups are called multis.

Setups can be imported.

PC3/PC3K/PC3LE setups can have up to 16 zones.
SP4/SP5/Artis setups/multis can have up to 4 zones.

- Only the first 4 zones will be imported.

- If there are user programs in the same file and the setup uses those programs, then everything will sound ok. The programs will be imported with the setup and the setup will sound ok.

- If the setup uses factory programs, then the setup will NOT sound ok in SP4 and Artis. Because SP4 and Artis has a different program list than the PC3/PC3K/PC3LE. SP5 will be ok related to this as it uses basically the PC3LE program list. So, SP4 users out there, this is a typical case you will see while importing some setups from ksetlist. Some will not sound ok for you because the programs are just not there.
Regards,

Fran
http://www.hipogrito.com
Yes I work at Kurzweil but anything I write here is just on behalf of myself, not the company.
User avatar
hipogrito
Site Admin
 
Posts: 926
Joined: Sat Feb 26, 2011 12:43 pm
Has thanked: 1121 times
Have thanks: 317 times


Return to FAQs

Who is online

Users browsing this forum: No registered users and 1 guest


cron