Is it possible to send a program, a KB3 sound or a single sound in a Setup only to the AUX OUTPUT or only to the MAIN OUTPUT of the PC3? If it is possible how can I do that?
I need to drive an organ sound to an external phaser - mxr phase 100 - trought a specific channel of my mixer, but I don't want the same for the eventually other sounds of the setup I'm using.
Thanks
paozir

Yes, see page 7-4 of the original owners manual dated 5-27-11.

* - In your setup go to the zone that represents the KB3 program.
* - Go to the "CH/PROG" Page.
* - Change the "Out" parameter from 'Auto' to 'Sec'

From the manual: Out
Use the Out parameter to set the rear panel audio outputs used for each zone of the current Setup. This parameter determines the output settings for the main program signal and insert effects of each zone (for Aux effects output settings, use the Output parameter on the Setup Mode AUX1 or AUX2 pages.)

A setting of Auto will make that zone output audio based on the settings for the program used by that zone. Program output settings are set in the Program Editor using the Output parameter on the top line of PROG FX page (see Output on page 6‐48 for details) or the Output parameter on the LAYER FX page (see page 6‐49 for details.) A setting of Pri. (primary) will output track audio to the MAIN Balanced Analog Outputs. A setting of Sec. (secondary) will output track audio to the AUX Balanced Analog Outputs.

Another reference too:

http://kurzweil.com/knowledgebase/pc3/setup_mode/255/