I just bought a PC3K:
I would like to increase the stroke of distortion effect control by mwheel in KB3 mode. I wish when wheel is set to minimum, the distortion effect would be zero, but at maximum I'd like it much more "hard".
I looked in the manual but I can not find any reference.
Someone has already tried to change these parameters?
Thanks!
Emilio
Thanks to you I found the page to be edited. Perfect as I wish!.Quickly reading the manual I had not understood how to set those parameters. The manual is in English and I'm Italian: I do a little 'hard to understand. Indeed, I ask forgiveness for my "googled" English.
Thanks again, your explanation was very useful to me!
Emilio
The easiest way might be to find a parameter inside the FX distorion page that is connected to the "Wheel".
Change the amount of control it is given. You might have to strengthen the overall distorion to get more on full wheel up, and lower the amount of the wheel on zero position. It depends on how it is programmed.
You might have to even out the parameters for drive level and the amount of control the wheel is given over it.