Hello
I have a PC3K6 since a couple of weeks, Im really happy, I use to play a Roland.
I started with the video tutorials. Now Im learning to create Setups by editing. I dont know how to activate any Zone as SOLO, I created a 3 zones (3 ACTIVE programs) in the entire range of the keyboard and when I press the BANK zone this only allows me to MUTE any of the zone but not to put in SOLO.
Thanks for your help.
I quote from the manual:
To solo a zone, set the Status parameter on the Setup Editor CH/PROG page (see The Setup Editor
and The Channel/Program (CH/PROG) Page below) to Solo. The Chan/Layer buttons—in addition to scrolling through the zones of the current setup—now select the soloed zone. If you scroll through zones 1-8, you will see the red solo LED moving across the bank buttons above the sliders. After one zone is soloed, you can solo zones 1-8 by pressing on the corresponding Bank button above the sliders; this action unsolos the previously soloed zone.
Additionally, you can configure a setup such that you can solo zones in real time (from outside of the editor) by assigning a controller on the desired zone to destination 162 SoloZn. See Controllers on page 7-19 for more information on controller destination assignments in Setup mode.
Forte | K2000
Thank you very much!
When I do that, always is some zone soloed 1 at least, but what happend if I want to play maybe 3-4 zones and after that soloing any zone, is it possible?
Thanks again
Thank you very much!
When I do that, always is some zone soloed 1 at least, but what happend if I want to play maybe 3-4 zones and after that soloing any zone, is it possible?Thanks again
You can use the destination 126 SoloZn.
Let's say you have a 4-zones setup and you want to solo zone 2 with the SW button. Edit the setup, go to zone 2 with the chan/layer buttons, SWITCH page:
Type: Toggled
OnControl: 126 SoloZN
OnValue: 127
OffControl: 126 SoloZN
OffValue: 0
Forte | K2000
