Forum

I agree. When the same occurred to me I looked for partial spare parts but with no success. I planned to follow Bill's directions and build a couple ...

Something (maybe your nickname!?) tells me this is NOT your first Kurzweil Welcome!

To get the patch without using Facebook you may send an email to Libor asking for it. I don't know if I can write the address here without making his ...

This is just to inform you (not everybody uses FaceBook ) that Libor programmed an updated version of his B3 organ which sounds even better (in part...

This is just to inform you (not everybody uses FaceBook ) that Libor programmed an updated version of his B3 organ which sounds even better (in part...

I have the same issue on my PC3K. Sent to assistance, they told it's a common problem and they do not fix it if the noise level is under a given level...

Hi John, My first suggestion were wrong. Sorry about that. These are the correct parameters (works with kurz pedal): SetupMode:FOOT SWITCH 3 Type: M...

Can't wait to try this out. Me too BTW, just to avoid messing the forum, this should be the place for sound requests. Shared sounds should be put ...

In fact I wrote the 12K value was fine, and the whole idea is really good Regards C.

You were really too tired 1/Rtot = 1/R1 + 1/R2 (it's the actual relation for two resistors in parallel and the one I wrote) so (common denominato...

Ehm!... The modding solution Gary proposed is fine, and the 12K is also fine, but the correct equation is 1/(10K)=1/(50K)+1/x

I've visited Malc's site (I didn't know of its existence before) and I WAS impressed. Great sounds there hope they will be available soon.

Try putting CC 140 (SetupDec) on the footswitch on 3 zones of your last setup (if you do not have 3 add enough mute zones just to add this control)

Go to FTSW2 page in one zone of each setup which has to behave this way, then set: Type: momentary On Control: CC 139 (SetupInc) On Value: 127 Do this...

Ciao Alex, welcome (also) here ! C.