Last seen: May 25, 2025
Don't be daunted. If you could get your head around the EPS, the PC3LE will be a breeze. Basically its a similar architecture to the EPS, Sample -&g...
I think it will depend on the licence conditions on each of the soft synths sampled as to what is allowed and what isn't. Licence conditions vary wid...
Toolbox (available to Cunka Subscribers) will allow you to inspect what makes up programs and setups. A guide for the PC3 is available at Cunka that ...
I'm pretty sure if you have buttons turned on (MIDI or Master Page - I can't remember), then the buttons will transmit across MIDI. You just have to ...
Luigi, It might be worth touching base with Brian over at Cunka about this stuff. He's built toolbox which looks inside Kurzweil files and has a goo...
Hello back from Perth...
It depends very much on the particular drum program that is being used. I don't tend to use the Kurzweil preset drum programs, instead I make my own ...
Drum mapping in the PC3 is a little complicated, but I'll try to cover things here. Firstly, at the keymap level, you can assign any sound to any key...
I use program changes only with Ableton. I stick everything in 1 bank and leave it there. There was a bug sending bank change messages on Ableton Li...
Some people have had success formatting these cards in a camera, rather than on a PC or the PC3. You're getting into grey territory with large cards....
Depending on the sample rate, Kurzweil instruments can transpose up by a maximum of 1-2 Octaves. The maximum playback rate on K2600's is 96 kHz, so a...
If this is the sound that I programmed, you might be running into problems with transposition limits on some of the samples, especially if the pitchbe...
Just to add to that. The Aux FX are global to the machine, and are controlled by a single MIDI channel. In program mode, the current program's Aux F...
What I'd love to see is the ability to change the MIDI channel of a riff via a controller, at the loop point. (ie select the playback channel that con...