Last seen: Dec 17, 2023
If you find that the pitchbend wheel is defective but still want/need pitchbend you could assign pitchbend to a different controller, like the mod whe...
For programs, control setup #126 controls how controllers react universally for programs. So go into control setup #126 and disable the pitchbend whe...
Experiment:. Disable the pitch wheel and see if the phenomena stops. If it does then the pitch wheel is failing and needs to be replaced.
One other possibility is that the jack you are plugging your pedal into is going bad. If it does it try reassigning the leslie switching function to ...
If it were my keyboard I would follow the process that loads the operating system, which is a memory clean and an operating system reinstall. Once the...
I think there is a way around the key/vel page trick where you are setting the high note below the low note so the Juno doesnt respond to the Kurz's k...
So then based on your latest report the Kurz is either not sending a program change OR the Juno is not setup properly to receive the program change, s...
It would only be "normal" if you wanted consistent volume across or wanted different volumes, but all hammonds have the top octave scream fa...
Sounds as though it is working but is calling up the GM patches rather than the user patches. And the fact that you said that you changed the midi pro...
It's part of the organ, it's not a leslie parameter. I guess the SP6 doesn't support the detailed organ parameters because it is a stage piano rather...
I dont have an sp6 but on the pc3 series there is a parameter called "uppervoladjust" on the tonewheel page. Reducing the amount of this pa...
First, ensure the LE is set to send program changes via midi. See page 9-16 in the manual in the master mode section (progchange). This must be set to...
Pro piano with my own tweaks....
The control setup #126 controls all of the controllers for programs, but not for setups. So in each zone of the setup you need to tell that zone what ...
Assigning SW switches to mute layers (not sure what cc# it would be) would allow you to turn layers on and off and thus allow certain instruments to ...